WinTrax Wheel Aligner Sales Guide

This is a Sales Guide to point out the ADVANTAGES of the FASEP Wheel Alignment System.

1. FASEP CONTACT CLAMPS DO NOT NEED TO REMOVE PLASTIC COVER FROM RIMS
   
   –with the 3D system, clamps are directly on the rim: the plastic wheel covers (if any) must be removed and nail-adapters must be changed if there are different types of rims between two different cars; all this leads to a waste of time.
   –FASEP contact clamps are directly on the wheel and it is only necessary to adjust the position of diameter to touch the tire.
   
   
2. FASEP CLAMPS DO NOT NEED TO DO RUN OUT COMPENSATION
   
   –with 3D system you have to make the run-out compensation, that is move the car back and forth.
   This causes: loss of time, risk of falling of the clamps, bad safety for the worker, hard to move heavy vehicles.
   Also compensation cannot be done on 2 posts lift.
   -with FASEP, compensation is not needed!
   
   
3. FASEP CONTACT CLAMPS ARE DRAMATICALLY SAFE while we experienced a lot of falls with our old rim clamps since over 5 years factory maintenance for fallen contact clamps is practically zero.
   With the rim-clamps, on the other hand, there is a risk that it may fall (to prevent this clamps are equipped with safety cord hooks).
   Also in this case there is waste of time.
   
   
4. IN FASEP WINTRAX THERE IS NO INSTALLATION DISTANCE LIMITS.
   With 3D system there must be a min and max installation distance between cameras and targets.
   
   
5. WITH FASEP WINTRAX YOU CAN WORK ON ANY LIFT YOU HAVE, just move the trolley and the sensors.
   3D system is installed for only one lifter, it cannot be moved.
   

Take a look to the Advantage manual for more informations


Take a look at our Theory for a wider view of the Wheel Alignment